Menu
- Products
- Hydraulic seals
- Hoses and fittings
- Filtration
- Measurement and sensors
- Valves
- Directional valves
- Proportional valves
- Relief valves
- Check valves
- Overcenter Valves
- Sequence Valves
- Pressure reducing valves
- Flow restrictors
- Flow Regulators
- Flow Dividers
- High-Low Valves
- End-of-stroke valves
- Ball Valves
- Other Valves
- Manifold blocks and subplates
- Monoblock and sectional valves
- Coils, connectors and electronics
- Pressure intensifiers
- NEM - Cartridge valves
- Hidro Orfão Systems
- Pumps
- Transmission
- Motors
- Accumulators
- Cooling
- Hydronit - compact power packs
- Crimping machines
- Industrial consumables
- Pneumatics – End of stock
- Brands
- Utilities
- Advanced search
MAP3 joystick with friction - marine
€765.52
Tax included
(622.37 € Excluding VAT. VAT at the legal rate applies.)
Single-axis electronic joystick, marine version, with friction hold and two PWM outputs for one proportional section.
Special marine version of the MAP joystick, single axis. This one has friction: the lever stays where you leave it.
It reads the position with Hall-effect sensors, with no contact and no wear, and drives the two coils of one section of a proportional directional valve directly, with closed-loop current control. It also has a digital output for the unloading valve, which switches on when either side is operated, and a fault output, which switches off if there is a failure.
- Supply: 12 or 24 V DC
- Factory setting: 250 mA minimum and 850 mA maximum on each side, ramps at zero, PWM at 100 Hz, linear curve
- Unloading valve: switches off 0.5 s after the proportional outputs stop
- Connection: 0.2 m cable with Deutsch DT04-8 connector
The values can be changed with the SepSim software and the AISR adapter, sold separately.
1.FBC.PMAP3SSLF
4 other products in the same category:
Viewed products
Are you an OEM? Reseller? Workshop?
Single-axis electronic joystick, marine version, with friction hold and two PWM outputs for one proportional section.