Menu
- Products
- Hydraulic seals
- Hoses and fittings
- Filtration
- Measurement and sensors
- Valves
- Directional valves
- Proportional valves
- Relief valves
- Check valves
- Counterbalance valves
- Sequence valves
- Pressure reducing valves
- Flow restrictors
- Flow control valves
- Flow dividers
- High-Low Valves
- End-of-stroke valves
- Ball Valves
- Other Valves
- Monoblock and sectional valves
- Coils, connectors and electronics
- NEM - Cartridge valves
- Manifold blocks and subplates
- Pressure intensifiers
- Hidro Orfão Systems
- Pumps
- Transmission
- Motors
- Accumulators
- Cooling
- Mini power packs
- Crimping machines
- Industrial consumables
- Pneumatics - End of stock
- Push-in fittings
- Brass and compression fittings
- Flow regulators and check valves
- Air treatment
- Coils and connectors
- Directional valves and solenoid valves
- Manual and mechanical valves
- Solenoid valves for fluids
- Silencers
- Pneumatic tubes
- Pneumatic cylinders
- Cylinder accessories
- Cylinder and seal kits
- Panel controls
- Brands
- Utilities
- Advanced search
Male JIC 90° long 7/8" hose fitting for 1/2" hose
* Preço sob consulta *
Price including VAT at the legal rate
Crimp male JIC 37° hose fitting, long 90° bend, 7/8" thread for 1/2" hose.
Crimp hose fitting with a male JIC end bent at 90°, in the long version: the bend leg is longer than standard, to move the connection away from obstacles or make tightening easier. 7/8" UNF thread with 37° cone, for 1/2" hydraulic hose.
- Thread: JIC 7/8" male, 37° cone
- Hose: 1/2" bore
- Bend: 90°, long
It is assembled with the right ferrule for the hose and crimped to the diameter in the crimping table. Before ordering, measure the thread and compare the bend length with the old fitting.
1.0904.90L7812
Specific References
- Internal barcode
- 2200111595015
4 other products in the same category:
Viewed products
Are you an OEM? Reseller? Workshop?
Crimp male JIC 37° hose fitting, long 90° bend, 7/8" thread for 1/2" hose.