Menu
- Products
- Hydraulic seals
- Hoses and fittings
- Filtration
- Measurement and sensors
- Valves
- Directional valves
- Proportional valves
- Relief valves
- Check valves
- Counterbalance valves
- Sequence valves
- Pressure reducing valves
- Flow restrictors
- Flow control valves
- Flow dividers
- High-Low Valves
- End-of-stroke valves
- Ball Valves
- Other Valves
- Monoblock and sectional valves
- Coils, connectors and electronics
- NEM - Cartridge valves
- Manifold blocks and subplates
- Pressure intensifiers
- Hidro Orfão Systems
- Pumps
- Transmission
- Motors
- Accumulators
- Cooling
- Mini power packs
- Crimping machines
- Industrial consumables
- Pneumatics - End of stock
- Push-in fittings
- Brass and compression fittings
- Flow regulators and check valves
- Air treatment
- Coils and connectors
- Directional valves and solenoid valves
- Manual and mechanical valves
- Solenoid valves for fluids
- Silencers
- Pneumatic tubes
- Pneumatic cylinders
- Cylinder accessories
- Cylinder and seal kits
- Panel controls
- Brands
- Utilities
- Advanced search
IGR polyurethane rod seal (GIP) 50x65.1x6.3
€21.22
Tax included
(17.25 € No tax)
IGR polyurethane rod seal (GIP), size 50x65.1x6.3, for a 50 mm rod.
Rod seal of the IGR profile, in the polyurethane version designated GIP. It fits in the cylinder head, around the rod, and stops the oil under pressure from escaping along it.
Size: 50x65.1x6.3, that is a 50 mm rod, a 65.1 mm groove bottom diameter and a 6.3 mm groove width. Please check all three dimensions against the groove or the old seal before ordering.
1.3328.5065163GIP
4 other products in the same category:
Are you an OEM? Reseller? Workshop?
IGR polyurethane rod seal (GIP), size 50x65.1x6.3, for a 50 mm rod.