Menu
- Products
- Hydraulic seals
- Hoses and fittings
- Filtration
- Measurement and sensors
- Valves
- Directional valves
- Proportional valves
- Relief valves
- Check valves
- Counterbalance valves
- Sequence valves
- Pressure reducing valves
- Flow restrictors
- Flow control valves
- Flow dividers
- High-Low Valves
- End-of-stroke valves
- Ball Valves
- Other Valves
- Monoblock and sectional valves
- Coils, connectors and electronics
- NEM - Cartridge valves
- Manifold blocks and subplates
- Pressure intensifiers
- Hidro Orfão Systems
- Pumps
- Transmission
- Motors
- Accumulators
- Cooling
- Mini power packs
- Crimping machines
- Industrial consumables
- Pneumatics - End of stock
- Push-in fittings
- Brass and compression fittings
- Flow regulators and check valves
- Air treatment
- Coils and connectors
- Directional valves and solenoid valves
- Manual and mechanical valves
- Solenoid valves for fluids
- Silencers
- Pneumatic tubes
- Pneumatic cylinders
- Cylinder accessories
- Cylinder and seal kits
- Panel controls
- Brands
- Utilities
- Advanced search
ROTEX machined hub GHC 101A
€12.78
Price including VAT at the legal rate
(10.39 € Excluding VAT. VAT at the legal rate applies.)
ROTEX coupling hub, already machined, part number GHC 101A.
ROTEX type half coupling, already machined, part number GHC 101A. The ROTEX is a flexible jaw coupling: two hubs with an elastic spider between them, which transmits the torque and absorbs vibration and small misalignments between motor and pump.
The part number does not tell us, in a way we can confirm, the coupling size or the bore. Before ordering, compare it with the hub you are replacing (ROTEX size, bore diameter and type, keyway or taper) and choose a spider of the same size.
1.2020.101A
Specific References
- Internal barcode
- 2200009891106
4 other products in the same category:
Are you an OEM? Reseller? Workshop?
ROTEX coupling hub, already machined, part number GHC 101A.