Menu
- Products
- Hydraulic seals
- Hoses and fittings
- Filtration
- Measurement and sensors
- Valves
- Directional valves
- Proportional valves
- Relief valves
- Check valves
- Counterbalance valves
- Sequence valves
- Pressure reducing valves
- Flow restrictors
- Flow control valves
- Flow dividers
- High-Low Valves
- End-of-stroke valves
- Ball Valves
- Other Valves
- Monoblock and sectional valves
- Coils, connectors and electronics
- NEM - Cartridge valves
- Manifold blocks and subplates
- Pressure intensifiers
- Hidro Orfão Systems
- Pumps
- Transmission
- Motors
- Accumulators
- Cooling
- Mini power packs
- Crimping machines
- Industrial consumables
- Pneumatics - End of stock
- Push-in fittings
- Brass and compression fittings
- Flow regulators and check valves
- Air treatment
- Coils and connectors
- Directional valves and solenoid valves
- Manual and mechanical valves
- Solenoid valves for fluids
- Silencers
- Pneumatic tubes
- Pneumatic cylinders
- Cylinder accessories
- Cylinder and seal kits
- Panel controls
- Brands
- Utilities
- Advanced search
Mechanical seal T40 (FPD) Ø35 mm, carbon/ceramic/NBR
* Price on request *
Tax included
Type T40 (FPD) mechanical seal for a Ø35 mm shaft, carbon and ceramic faces, NBR elastomers.
Mechanical seal: the rotary seal that closes the shaft of water pumps and other fluid pumps. It has a face that turns with the shaft and a stationary face, held together by a spring.
This one is type T40 (FPD), for a Ø35 mm shaft, with one carbon face and one ceramic face and NBR elastomers, a common combination in clean water pumps.
Before ordering, check the shaft diameter, the housing dimensions and the materials of the seal you are replacing.
1.3333.EMPT40FPD35
Specific References
- ean13
- 2200010001884
4 other products in the same category:
Viewed products
Are you an OEM? Reseller? Workshop?
Type T40 (FPD) mechanical seal for a Ø35 mm shaft, carbon and ceramic faces, NBR elastomers.