Menu
- Products
- Hydraulic seals
- Hoses and fittings
- Filtration
- Measurement and sensors
- Valves
- Directional valves
- Proportional valves
- Relief valves
- Check valves
- Counterbalance valves
- Sequence valves
- Pressure reducing valves
- Flow restrictors
- Flow control valves
- Flow dividers
- High-Low Valves
- End-of-stroke valves
- Ball Valves
- Other Valves
- Monoblock and sectional valves
- Coils, connectors and electronics
- NEM - Cartridge valves
- Manifold blocks and subplates
- Pressure intensifiers
- Hidro Orfão Systems
- Pumps
- Transmission
- Motors
- Accumulators
- Cooling
- Mini power packs
- Crimping machines
- Industrial consumables
- Pneumatics - End of stock
- Push-in fittings
- Brass and compression fittings
- Flow regulators and check valves
- Air treatment
- Coils and connectors
- Directional valves and solenoid valves
- Manual and mechanical valves
- Solenoid valves for fluids
- Silencers
- Pneumatic tubes
- Pneumatic cylinders
- Cylinder accessories
- Cylinder and seal kits
- Panel controls
- Brands
- Technical library
- Advanced search
Banjo Ø13 for 1/4" bolt
€1.38
Price including VAT at the legal rate
(1.13 € Excluding VAT. VAT at the legal rate applies.)
Banjo with Ø13 mm bore, for a 1/4" banjo bolt.
Banjo with a Ø13 mm bore, to be fitted with a 1/4" banjo bolt and two sealing washers. The banjo allows a line to be connected to a manifold, a valve or a cylinder in a short space and set in the required direction before tightening.
Before ordering, check the thread of the banjo bolt and the type of connection on the other end of the banjo (pipe, hose fitting or thread), comparing with the part being replaced or with the product photo.
1.0926.1314
4 other products in the same category:
Viewed products
Are you an OEM? Reseller? Workshop?
Banjo with Ø13 mm bore, for a 1/4" banjo bolt.